Electronics - Failsafe Units:

   

Price:
EMS-JOMAR 1-channel failsafe (servo setting failsafe)

A failsafe device that check for a missing signal from the transmitter. User settable servo position and time delay.

$38.00

 
     
1-channel failsafe with switch (switch failsafe) custom built by EMS-JOMAR for Mike's Subworks.

A failsafe device that checks for a missing signal from the transmitter. Pre-set 10 second time delay. Allows for manual activation of the failsafe from the transmitter.

 

$38.00

 
     
 AFS-2 Failsafe (new and improved!)

NEW SMALLER DESIGN!

Designed specifically for the PBU Propel Back Up System, the AFS Failsafe is a device which monitors receiver output. If the output is interrupted for more than 7 seconds, a transistor goes "high" which then activates the solenoid valve to "blow" ballast. Can be used to control any on/off device. AFS can be connected to any channel by using a "Y" connector and is not affected by transmitter stick movement.

 

 $28.95

 

 
SubSafe-2 (new and improved!)

NEW SMALLER DESIGN!

SubSafe is a missing pulse detecting 'failsafe' which continuously monitors the output of the receiver. When connected between the receiver and a servo, SubSafe will automatically move the servo to any position chosen by the user. Can be used to control a servo, electronic switch, or any device which is normally controlled by the receiver. To prevent false activation in case of a momentary 'glitch', SubSafe has a built in delay of 7 seconds (easily changed). Ideal for both submarines and gas powered speed boats! SubSafe measures only         1 1/2" x 3/4" x 3/8".

Units available with or without a servo extension wire.

 $34.00

 

 
     
*All electronic devices come equipped with Universal / JR / Hitec connectors. Actual device may vary slightly in appearance from picture.    

* Prices and availability subject to change without notice.

You are the  Hit Counter visitor to this page

Home