End Caps:
General information:
End caps are used to seal the tubing used as a pressure hull. Different sized end caps are needed for the corresponding tubing. All internal equipment is bolted to the inside face of these end caps. O-ring seals are used to insure watertight integrity.
|
|
|
| Available in the following sizes: | Prices: |
| For 2.50" OD tubing | $25.00 |
| For 3.00" OD tubing | $29.00 |
| For 3.50" OD tubing | $34.00 |
| For 4.00" OD tubing | $38.00 |
MADE TO ORDER Allow 4 - 5 weeks for delivery DLX End Caps fits 3.00" OD tubing |
$69.00 |
|
|
|
|
Mark II End Caps for 2.50" OD Tubing Designed for 2.50 OD Lexan tubing. Used between the battery compartment & ballast tank and between the ballast tank & pressure hull.
|
$35.00 |
|
Mark II End Caps for 3.00" OD Tubing Designed for 2.50 OD Lexan tubing. Used between the battery compartment & ballast tank and between the ballast tank & pressure hull.
|
$45.00 |
|
Mark II End Caps for 3.50" OD Tubing Designed for 2.50 OD Lexan tubing. Used between the battery compartment & ballast tank and between the ballast tank & pressure hull. |
$55.00 |
* Prices and availability subject to change without notice.
You are the visitor to this
page
